Fabric Covered Mould Buttons for Wholesaler

Covered Mould Button

Sketch Map	Name	INSTRUCTION:
	Pusher	(For use with 5/8” cover button kit) 1.Cut pattern from back of package and place on fabric. 2. Use pattern to cut fabric circle. Then center fabric circle (wrong side up) over mold. 3. Hold fabric securely while pressing button shell into mold. 4.Tuck excess fabric into button shell. Position back and use pusher to press down back until it snaps into place.
	Back
	Button Shell
	Fabric
	Mold


Aluminum face and bottom 0301-5007 16L--100L	Aluminum face with aluminum wire bottom 0301-5907 16L--80L	Aluminum face with iron wire bottom 0301-5023 16L--80L	Aluminum face with flat bottom 0301-5705 16L--80L

Aluminum face with white plastic bottom 0301-5107 16L--80L	Aluminum face with black plastic bottom 0301-5107 16L--80L	Aluminum face with small-hole bottom 0301-5706 16L--60L	Hemispherical aluminum face and bottom 0301-5602 16L--60L

Straw hat ring 0301-5707 16L--50L	Aluminum face and bottom, Paris 0301-5069 12mm-50mm	Aluminum face with horizontal hole bottom 0301-5070 12mm-50mm	Iron face and bottom 0301-5405 14mm-38mm